UPM THM301A Guide d'installation télécharger pdf (Page 12)

MOUNTING THE THERMOSTAT BACK-COVER

l The back-cover should be mounted horizontally

with the terminals on the left side.

l Thread the existing wiring through the big center hole

from the back and set the back-cover horizontally on the wall.

l Select two appropriate mounting holes and mark

the locations with a pencil. If necessary, use a level

to make sure the thermostat is leveled.

l Remove the back-cover from the wall and drill

two 3/16 inch holes in the marked screw positions.

Insert the wall-anchors into the holes completely.

If necessary, use a hammer to tap-in lightly.

l Mount the back-cover with the two screws to the wall.

Make sure the metal terminals are on the left side.

Back-Cover

Mark the locations

with a pencil.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Pas de commentaire

UPM THM301A Guide d'installation Page 12