UPM THM301A Guide d'installation télécharger pdf (Page 9)

- AA SIZE +

Two AA size batteries (included)

Wire Stripper/Cutter

(If necessary, to strip the wires)

Level

(If necessary, to level the thermostat)

Masking Tape

(To wrap the exposed wires temporarily and labeling

the disconnected wires)

Hand Power Drill with a 3/16 inch bit

( If necessary, to drill holes on the wall )

Cross screwdriver

The following tools may be required for installation:

See below to select a suitable place for the new thermostat installation. And refer to Replacing Old

Thermostat section to replace old thermostat.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Pas de commentaire

UPM THM301A Guide d'installation Page 9